Uline H-8400 Mode D'emploi page 4

3. For Mobile Tables Only: Using a
17 mm wrench, attach casters with
four bolts, flat washers, lock washers
and nuts included in the caster pack.
Put casters in locking position.
(See Figure 8)
4. Carefully set table upright and
recheck all screws for tightness.
MAPLE TABLETOP FIELD JOINT ASSEMBLY
1. Lay top sections with field joint slots facing up on a
smooth, non-marring surface to protect top sections
from damage. (See Figure 9)
Figure 9
PAGE 4 OF 12
ASSEMBLY CONTINUED
2. Push top sections together so surface sides are flush
Figure 8
3. Place a tite joint fastener (included) in each field
joint opening. (See Figure 10)
Figure 10
4. Using a 7/16" wrench, snug the tite joint fastener so
that both top sections are clamped together. Align
the faces and edges to be flush before completely
tightening the field joints. Gently adjust each section
with a piece of wood and rubber mallet to avoid
damage to the tabletop, then finish tightening.
5. Before turning tabletop over, see Top Assembly
instructions on page 3.
1-800-295-5510
uline.com
0323 IH-8400