Uline H-8400 Mode D'emploi page 2

LEGS AND FRAME ASSEMBLY
NOTE: Tabletops add 1⁄ – 1⁄" depending on
top purchased.
1. Flip legs (1, 2) upside down. Place adjustable
feet (3) into legs and slide to desired height. Fasten
adjustable feet to legs with two M10 x 65 hex bolts
and two M10 nuts per adjustable foot using a 17 mm
wrench. (See Figure 1)
Figure 1
M10 x 65
Hex Bolt
Leg
2. Turn legs upright and spread apart to
accommodate frame support bars (4). Position
frame support bars so larger holes are facing
down. Open end of frame support bars should be
positioned on the center leg (1). Fasten support bars
to outside leg (2) with four M8 x 65 hex bolts per leg
using a 13 mm wrench. (See Figure 2) Repeat for
other side.
Figure 2
Center Leg
M8 x 65
Hex Bolts
PAGE 2 OF 12
Adjustable
Feet
M10 Nut
Leg
Frame Support Bars
ASSEMBLY
3. Place center leg support bar (6) between frame
support bars (4) on top of the center leg. Fasten
center leg support bar to frame support bars and
center leg (1) with eight M8 x 65 hex bolts using a
13 mm wrench. (See Figure 3)
Figure 3
Center Leg Support Bar
M8 x 65
Hex Bolts
0323 IH-8400