SOLAC Beauty & the Beast 1500W Mode D'emploi page 8

ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Stop the appliance, selecting position 0 on the
•
selector control.
Unplug the appliance from the mains.
•
Lift the jar from the motor body.
•
Clean the appliance.
•
"PULSE / ICE CRUSH" FUNCTION
The appliance works in highest speed to achie-
•
ve optimal performance.
This function gives optimal result for ice-crus-
•
hing, up to desired snowy level.
Trun the speed selector knob to the left to ope-
•
rate the Pulse function (J).
We recommend working by turning the knob in
•
cycles of 3 seconds and repeating the opera-
tion until you obtain the desired result.
SAFETY THERMAL PROTECTOR:
•
The appliance has a safety device, which pro-
•
tects the appliance from overheating.
If the appliance turns itself off and does not
•
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
Disconnect the appliance from the mains and
•
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
•
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid
•
or base pH such as bleach, or abrasive pro-
ducts, for cleaning the appliance.
Do not let water or any other liquid get into the
•
air vents to avoid damage to the inner parts of
the appliance.
Never submerge the appliance in water or any
•
other liquid or place it under running water.
During the cleaning process, take special care
•
with the blades, as they are very sharp.
If the appliance is not in good condition of clean-
•
liness, its surface may degrade and inexorably
affect the duration of the appliance's useful life
and could become unsafe to use.
The following pieces may be washed in a di-
•
shwasher (using a soft cleaning program):
Jug
•
Cup
•
Lid.
•
Then dry all parts before its assembly and sto-
•
rage.
SELF-CLEANING FUNCTION:
Put water and a small amount of washing up
•
liquid in the jar.
Select the function "turbo".
•
REMOVABLE BLADES FOR EFFECTIVE
CLEANING:
Disconnect the appliance from the mains and
•
allow it to cool before undertaking any cleaning
task.
Loosen the jar base by turning it in counter-
•
clockwise direction. (Fig.3).
Remove the blade set, sealing blade ring and
•
jar base and clean them. (Fig.4).
After cleaning, replace the blade set and turn
•
blade fixing ring in opposite direction. (Fig.5).
EN