Publicité
Les langues disponibles
Les langues disponibles
Setting Temperature For Hands Free Operation
You can set the temperature of the water for hands free operation by adjusting
the temperature control knob on the control box. Note: Be sure to have the
manual faucet lever turned off or it will interfere with this setting.
How To Change Flow-time Of Hands Free Operation
• locate the ON-OFF switch on the control box and switch to OFF (O) for a period of 5 seconds... then switch back to ON (I).
• You can program the flow time during the first 5 seconds after the power is switched on. During this 5 seconds a red light in
window will turn on and stay lit for a 5 second period. To program, place your hand in front of the sensor while the light
• As you keep your hand in front of the sensor the light will begin to blink at one second intervals. Each blink will account
automatic run time (e.g. 4 blinks = 20 seconds). The maximum flow time is at 45 seconds or 9 blinks.
Note: beyond 9 blinks the unit will set the maximum flow time (45 seconds).
• After the desired number of blinks, remove the hand, wait a few seconds and the sensor will blink 3 times to confirm the new
• On power-off conditions the last programmed parameters are retained in memory.
Changing Batteries
• When the red light flashes continuously, the batteries need to be changed.
• Remove the sensor control box cover by unscrewing the left hand screw.
• Carefully unplug and remove the battery pack.
• Remove old batteries and install 4 fresh "C" sized batteries (taking care to observe the required battery polarity) into the battery pack.
• Re-insert battery pack into the sensor control box cavity and re-connect plug.
• Re-install sensor control box cover taking care not to pinch wires.
• Turn on faucet by pushing ON-OFF switch to ON (1).
Care + Maintenance
Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive
cleaners, steel wool and harsh chemicals as these will dull the finish and void your warranty.
Hands Free Operation Trouble Shooting Guide
Confirm that the faucet is working properly in manual mode by operating the manual water handle. If the water flow can
be properly turned on and off, turn off the manual activation and proceed to check the automatic functions as shown below.
1.
An object is within detection range but there is no water flow and the red light is not lit.
• Turn the power off and on using the NO-OFF switch on the sensor control box and confirm result.
• If the red light is still not lit, check the electronic power connections (AC plug in/battery/battery connection).
© 2009 Danze, Inc. All rights reserved.
Cold
Hot
the sensor
is on.
for a 5 second
run time.
Publicité
