Hama DT60 Notice D'utilisation page 7

1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to
draw your attention to speci c hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
Risk of electric shock
This symbol indicates product parts energized with a
dangerous voltage of su cient magnitude to constitute
a risk of electric shock.
2. Package Contents
• Digital tuner DT60
• Remote control
• 2x AAA batteries
• Quick guide
• AC/DC Adapter
3. Safety Notes
• The product is intended for private, non-commercial use
only.
• Protect the product from dirt, moisture and overheating
and use it in dry rooms only.
• As with all electrical devices, this device should be kept
out of the reach of children.
• Do not drop the product and do not expose it to any
major shocks.
• Do not operate the product outside the power limits given
in the speci cations.
• Keep the packaging material out of the reach of children
due to the risk of suffocation.
• Dispose of packaging material immediately according to
locally applicable regulations.
• Do not modify the device in any way. Doing so voids the
warranty.
Risk of electric shock
• Do not open the device or continue to operate it if it
becomes damaged.
• Do not use the product if the AC adapter, adapter
cable or power cable is damaged.
• Do not attempt to service or repair the device
yourself. Leave any service work to quali ed experts.
Warning – Batteries:
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking
or exploding.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries or batteries of a
different type or make.
• Remove the batteries from products that are not
being used for an extended period
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a re.
• Keep batteries out of the reach of children.
4. Getting started
4.1 Switching the device on
• Connect the power cable to a properly installed power
socket.
Warning
• Only connect the product to a socket that has been
approved for the device. The electrical socket must
always be easily accessible.
• Disconnect the product from the power supply using
the on/off switch – if this is not available, unplug the
power cord from the socket.
• Wait until the radio initialisation procedure has nished.
• Press the [POWER] button to switch the radio on.
3