Essilor CP550EA Manuel D'utilisation page 93

Whenever applying a mask to either the first or last element of a test, the device makes the transition to the
previous or subsequent test and then applies the mask to either the first or last element of this new test.
11.2. Program mode
11.2.1. Recording a program
6- Hold the "PROGRAM 1" or "PROGRAM 2" button (15) down for at least 5 seconds.
A signal rings three times, and the device projects the first recorded test and mask pair. The
test had been previously recorded.
If the "Automatic stop" function has been activated, start by pressing the LAMP button for a test to appear, then
hold the "PROGRAM" button down for at least 5 seconds.
7- Use the remote control in order to project the test or mask that you would like to store in memory.
8- Press the LAMP button to memorize the displayed test or mask.
9- The sound signal rings one more time and either the
and 3.
You can record up to 48 different tests. Beyond this number, a signal will ring twice and the projector will
indicate that it is unable to enter any more recordings.
10- To memorize your programming sequence, press either the "PROGRAM 1" or "PROGRAM 2" button (15),
depending on what you selected in step 1.
A signal sounds three times. The recording is now completed. The memorized program is saved even if the device
has been turned off.
Special manipulation
To return to the first test: press
To return to the last test: press
To delete all recorded tests: press
signal will ring three times.
The "Automatic stop" function remains inactive when entering a program.
11.2.2. Working in Program mode
3- Press the "PROGRAM 1" or "PROGRAM 2" button (15).
The device projects the first recorded test and mask pair.
If the "Automatic stop" function has been activated, start by pressing the LAMP button.
4- Press the "NEXT" button (22) to project the next recorded test or mask, or press the "BACK" button (21) to
project the previous test or mask.
If the test or mask happen to be the first ones, a signal will ring twice and the device will indicate the
impossibility of shifting any further back.
If you press the Test/Mask button, the Program mode will stop and the device will return to normal mode. It will
also stop if the LAMP button is pressed.
ESSILOR UMCP550 V1 OCT2015
test or memorized test is displayed. Repeat steps 2
(20) followed by the "NEXT" button (19).
(20) followed by the "BACK" button (19).
(20) followed by the "LAMP" button (13) held down for 5 seconds. A
18
test is projected if no