Publicité
Les langues disponibles
Les langues disponibles
Quick Start-en.book Seite 8 Dienstag, 22. Juni 2004 1:33 13
Installation
Checking the printer
voltage
en
op
ll to
pu
Front side of printer
Back side of printer
8
Make sure that the device has been set to the correct voltage (e.g. 230 V in Europe,
120 V in the USA). To do this, check the type plate above the power inlet at the
back of the printer.
Never switch on the printer if the voltage setting is incorrect, since this may result
STOP
in severe damage.
You can set the printer to the correct mains voltage yourself.
To do this, cautiously place the printer on its back side.
en
op
ll to
pu
Use a suitable object (e.g. a screwdriver, but never a pencil)
to set the slide switch on the left at the bottom of the printer
to the correct voltage.
120 V
230 V
Quick start guide
Publicité
