LEGRAND 028663 Guide Technique page 134

DMX
Objet
134
3
Manual control
Draw-out cell
Motor operator
Aux contacts and alarms
Insert/draw-out contacts
Shunt trip coil
Closing coil
UVR coil
Key lock/pad lock
Cable interlock
discharged
discharged
Check
discharged
charged
To performe at least two opening/
charged
closing cicles
discharged
discharged
discharged
discharged
discharged discharged
discharged
charged charged
charged
discharged
charged
discharged discharged
discharged
discharged
discharged
discharged discharged
charged discharged
charged
discharged
discharged
charged
discharged
To performe at least one cycle
insert/test/draw out postion
discharged discharged
Supply the motor operator
discharged
and perform at least 2 cycles
opening/closing . The motor
operator must load the springs after
each opening/closing event and
stop when the springs are ready
To verify the correct signals
To verify the correct signals
Close the breaker
Supply the coil and verify
the tripping
Open the breaker
Supply the coil and verify
the closing
Cut the UVR power and check the
breaker tripping .
To verify that it's impossibile
to close the breaker without UVR
power .
To verify the proper functioning
Adjust and verify
the proper functioning
0.5
0.4
xIr
ON
0
I>.9 .05
I>1
discharged
Remark
e d
a rg
c h
d is
@1 2Ir
I 2 t=k
0.3 0.2
tm
0.3
s
6
Im 0.0
M= OFF
ME
xIr 10
tr
Ii 6 12
s
0.1 Ir
xIn 0.08 @6
Icw
2
0.04 xIn
0.9
0.8 0.02
Ir 0.00
0.6 N
0.5
0.4
xIr
ON
I>.9 0
I>1 .05
charged