Matrix EJS 750-L Traduction De La Notice Originale page 35

Position 1-2 = low stroke speed (for steel)
Position 3-4 = medium stroke speed (for steel,
soft metal, plastic)
Position 5-6 = high stroke speed (for softwood,
hardwood, soft metal, plastic)
8.4 Setting the pendulum action (Fig. 10)
• The strength of the pendulum action of the saw
blade (12) can be adjusted using the selector
switch for pendulum action (8).
• You can adjust the cutting speed, the cutting
performance and the finish to the workpiece you
wish to saw.
The best combination of speed and pendulum
action depends on the material you wish to saw.
We recommend you to make a trial cut on a waste
piece in order to check the ideal settings.
8.5 Using the laser (Fig. 11)
• The laser (16) enables you to make precision
cuts.
• The laser light is generated by a laser diode.
The laser light is enlarged to form a line and is
emitted through the laser emission aperture.
You can then use the line as an optical marker
for the sawing line for precision cuts. Follow
the laser safety instructions.
• Use the switch for the laser (4) to switch the
laser off.
• The laser beam can be affected by deposits
of dust and chips. The emission aperture of the
laser beam must therefore be cleaned after
each use.
• Always switch off the laser when not in use.
8.6 Inserting/Changing the batteries (Fig.12-
13)
Open the battery housing (17).
Put two AAA 1.5V batteries (19) in it or replace the
flat batteries.
Caution! Two AAA 1.5V batteries are not in
delivery.
8.7 Making cuts
• Ensure that the ON/OFF switch (3) is not
depressed. Only then should you connect the
mains plug to a suitable socket.
• Do not switch on the jigsaw until you have fitted
a saw blade.
• Use only saw blades that are in perfect condition.
Replace blunt, bent or cracked saw blades
immediately.
• Place the saw foot flat on the workpiece you
wish to saw. Switch on the jigsaw.
• Allow the saw blade to accelerate until it reaches
full speed. Then slowly move the saw blade along
the cutting line. Only exert gentle pressure on the
saw blade as you do so.
• When cutting metal, apply a suitable coolant
along the line you wish to cut.
9. Replacing the power cable
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
aftersales service or similarly trained personnel to
avoid danger.
10. Technical data
Mains voltage:
Power input:
Stroke speed:
Cutting depth, wood:
Cutting depth, iron:
Miter cut:
Protection class:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level 87,5 dB(A)
pA
K uncertainty 3 dB(A)
pA
L sound power level 98,5 dB(A)
WA
K uncertainty 3 dB (A)
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
60745.
230-240 V~ / 50 Hz
750 W
0-3100 min
80 mm
8 mm
up to 45° (left and right)
II /
35
-1