Setup And Use; Setup As A Hammock Tent - Flying tent 000011 Mode D'emploi

Setup and use

1. Take the flying tent out of the packaging and the pack sack.
2. Check whether the delivery is complete (fig. a) and whether the flying tent or individual parts
exhibit damages. If this is the case, do not use the flying tent. Contact the manufacturer at the
specified service address.

Setup as a hammock tent

B
2
1. Take the flying tent
2. Undo the safety strap
3. Fasten the tree slings
around the tree trunk and pulling the end through the loop (fig. B). Repeat this process
with a second tree.
The trees should be at least 11.5 ft (3.5 m) and no more than 16.4 ft (5 m) apart.
4. Open the three tent floor clips
the tent floor clips with the outer tent clips
− If the prefitted quick release unit has been disassembled, hook the front loops on the quick
release unit into the carabiner clips
5. Secure the tree strap by running it through the clasp
6. Hook the outer tent clasp
7. Connect the other end of the quick release unit with the tree sling (fig. d).
8. Set the length of both quick release units so that the hammock tent is tensioned (fig. E).
E
SEtUP and USE
C1
C2
out of the pack sack
1
.
2
to two trees across from one another by wrapping the tree sling
2
that connect the ends of the tent poles
12
on the tent floor
4
into the rear loop
15
D
15 21
4
.
7
.
16
(fig. C2).
13
on the quick release unit (fig. d).
17
on the quick release unit (fig. C1).
21
14
and connect
8