Publicité
FRONT
I
3—)
REAR
1
(3
VOLUME
OPERATION
ADJUSTING THE VOLUME BALANCE
;g-q :
,&%i ~
Adjust the volume balance between the powered subwoofer
and
1$
the left and right speakers
of the connected
stereo system.
la-,-
1
Press the POWER
button.
r.+,..:
g~~st
The indicator
above the button lights up.
,:6.&
.....
2 Start playback
on the connected
stereo
system.
a="q
.7,,&
,,*.%
3 Adjust
the volume
of the powered
subwoofer.
!,, , *
-,",.~j
~z!%
., ~...
Moderate volume setting
To get natural
bass sounds,
adjust the volume
of the powered
subwoofer
according
to its position
and the graphic
equalizer
setting of the stereo system.
Adjustment examples
@
Set the VOLUME
control to a little lower than the middle when
the subwoofer
is
placed on the floor
and the graphic equalizer
is set to off.
@ Set the VOLUME
control to the middle when the subwoofer
is
positioned higher than the floor
and the graphic equalizer
is
set to off.
m
To avoid overloading
the powered
subwoofer,
do not set the
volume of the stereo system so high that the sound is distorted.
Low frequency
sounds
may
be distorted
when
they
are
emphasized
by the graphic equalizer on the stereo system. Adjust
the VOLUME
control on the powered subwoofer
or the graphic
equalizer
on the stereo system.
If the powered
subwoofer
will not be used for a long period of
time, press the POWER button to turn off the power, and unplug
the AC cord from the wall outlet.
CHANGING THE PHASE +
Depending
upon the room or the characteristics
of the right and
left speakers,
sound
from the powered
subwoofer
may seem
unnatural
or unusually
loud or soft.
In this case, try changing
the PHASE switch setting.
Set to the
NORMAL
or REVERSE
position,
whichever
sounds better.
USINGTHE AUTO POWER FUNCTION+
Before using this function,
make sure the POWER button is set to
ON.
While
the AUTO
POWER
switch
is set to ON, the power
is
automatically
turned on when receiving a signal input from either
INPUT 1 or INPUT 2.
The power is automatically
turned
off if no signal is input for a
while and the indicator of the POWER button becomes
dimmer, If
input signal is too weak, this function
does not effect.
While the AUTO POWER switch is set to OFF, the power is turned
on or off by pressing the POWER button.
8
Publicité
