Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
1. Preparing the tube
NOTE
The surfaces to be welded must be cleaned
immediately before welding. Protect the surfaces
from weather conditions.
2. Preparing the socket welder
A. Fix the adaptors corresponding to the
diameters of the tubes to be welded to the
heating plate. In no case they may protrude
from the periphery of the heating plate.
B. Connect
the
power
generator
C. Set the welding temperature: press
then the up
until the desired temperature is set and
then press again
12
A.
Cut the tube straight
across using a suitable
tool (pipe cutter or
cropper).
B.
Clean the surface
to be welded and the
adapters with cellulose
tissue dampened with
isopropanol.
C.
Mark the length of
the weld on the tube.
tool
to
the
mains
(230V.
/50
3.6
3.7
and down
3.4
to confirm the setting.
D. Wait for the temperature to reach the
setting. Approx. 7 minutes up to 260º, and
some 15 minutes total time to stabilize
the
3. Welding process
A. Heating: apply a slight pressure both to the
tube and the accessory to let the adapters
go into the corresponding tube or accessory
(tube to female adapter, accessory to
male adapter) for the time stated in table.
B. Assembly: Remove the tube and the
accessory from their adapters and introduce
one into the other (NO TURNING) up to
the weld depth mark. This operation must
be done as fast and carefully as possible.
C. Setting and cooling: the time for this
last stage is shown in the table. Make
sure no forces are exerted onto the
welding area during this time. When
the time is over, the welded tubes and
the accessories may be used following
tube
4. Weld checking
The weld lip must be uniform over the full rim.
Storage
When the equipment is no longer going to be used,
you are recommended to turn it off and allow it to
cool in order to store it. Store it carefully in a locked,
dry place out of reach of children.
Care and maintenance
Inspect the adapters before using them. Carefully
remove any material remaining from previous
welding operations.
PRECAUCION
Do not use metallic items or solvents to remove
residues, as these could damage the surface of the
adapter.
NOTE
or
Check the condition of the adapters from time to
Hz.).
time, to ensure correct welding.
3.4
,
7 arrows
ENGLISH
temperature
around
manufacturer
recommendations.
the
plate.
Publicité
