Peavey PV 15 PM Mode D'emploi page 17

T O p p a n e l
4
GROUND LIFT
4
Switches the XLR (5) PIN 1 from direct contact with ground in the event that hum occurs.
PRIMARY INPUT
5
The primary input is switchable between line-level and mic-level input. The line-level input is of the medium impedance
balanced type, and when switched to mic-level(6) it is of a typical low-Z mic input impedance. Jack (5) is a combo female
XLR and 1/4" TRS connector.
PAD
6
Switches the sensitivity of the primary input (5) from line-level to mic-level sensitivity. Pushed in, the sensitivity is set for
line-level input signals. When the switch is not pushed in, the sensitivity is increased by 30 dB so it is suitable for mic-level
signals.
PAD STATUS LED
7
Illuminates green when PAD switch (6) is in line-level mode, and yellow when the PAD is in mic-level mode.
VOLUME
8
Controls the gain (level) of the Primary Input (5) of the powered speaker system. It is used to directly set the system output
level for the input signal.
POWER/CLIP LED
9
Illuminates GREEN when the electronics receive power (when the Power switch (2) is On). Illuminates RED when amplifier
clipping is occurring or the unit has tripped the thermal protection system.
LINK OUT
10
Link Out is a 1/4" post-level send intended for the use of linking multiple PV
would connect to the 1/4" connections of the MIC/LINE (5) input of the next PV
PV 15 PM's in the line should have their respective PADs (6) engaged and Level control (7) set to mid-position. The first PV
®
can use it's level control to set the volume for all of the other PV speakers in the line.
DIRECT IN
11
Direct In is a 1/4" line input that can be used to drive the PV
input jack has switching contacts that disconnects the PV
not affect the volume of the speaker.
5 6 7 8
®
17
9 10
15 PM's in a line. In that case, the Link Out
®
15 PM in the line of PV speakers. All of the
®
15 PM directly from a mixer, or other line level source. This
®
15 PM pre-amp, therefore the level control on the PV
11
15 PM does
®