Publicité
Les langues disponibles
Les langues disponibles
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position.
Mower not starting.
Mower cutting grass unevenly.
Mower not mulching properly.
Mower hard to push.
Mower not bagging properly.
Mower vibrating at higher speed.
Motor stops while cutting.
This product has a Five-year Limited Warranty for personal,
family, or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com
TROUBLESHOOTING
POSSIBLE CAUSE
Handle adjustment knobs and/or handle
lock levers are not secured.
Battery is low in charge.
Start key not installed.
Handle assembly is not in operating
position.
Grass catcher, mulch plug, or side dis-
charge accessory not installed correctly.
Lawn is rough or cutting height not set
properly.
Wet grass clippings sticking to the un-
derside of the deck.
High grass, rear of mower housing and
blade dragging in heavy grass, or cut-
ting height too low.
Cutting height set too low.
Grass blocking rear chute of mower.
Blade is unbalanced, excessively or
unevenly worn.
Bent motor shaft.
Cutting height set too low.
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the RYOBI Help Line!
or call (toll free) 1-800-860-4050.
14 — English
SOLUTION
Make sure handle adjustment knobs
are fully seated and handle lock clips
are fully locked.
Charge the battery.
Install start key.
Raise lower and upper handle.
Check that grass catcher, mulch plug,
or side discharge accessory is installed
correctly.
Adjust the cutting height.
Wait until the grass dries before mowing.
Raise cutting height.
Raise cutting height.
Stop the motor, remove start key, and
battery. Remove grass catcher bag and
remove the blockage.
Replace the blade.
Stop the motor, remove start key, and
battery. Inspect for damage. Have re-
paired by an authorized service center
before restarting.
Raise the cutting height.
Publicité
