D
Cleaning
C aution!
C l e a n i n g
Avoid damaging the appliance and the
fittings.
Do not use abrasive, chloride or
■
acidic cleaning agents or solvents.
Do not use scouring or abrasive
■
sponges.
The metallic surfaces may corrode.
Never clean the shelves
■
or containers in the dishwasher.
The parts may become deformed.
Proceed as follows:
Switch off the appliance.
1.
Pull out the mains plug or switch off
2.
the fuse.
Take out the food and store in a cool
3.
location.
If present: place ice pack
on the food.
If present: wait until the layer of frost
4.
has thawed.
Clean the appliance with a soft cloth,
5.
lukewarm water and a little
pH-neutral washing-up liquid.
Caution!
The rinsing water must not run into
the light or through the drainage
hole into the evaporation area.
Wipe door seal with clear water and
6.
dry thoroughly with a cloth.
Reconnect and switch on appliance
7.
and put in food.
Cleaning the equipment
To clean, take the variable parts out of
the appliance.
~ "Interior fittings" on page 25
Partition and vegetable container
cover
Taking out the partition
~ Fig. *
Press levers on the underside on
■
both sides, pull partition forwards, lift
and swivel out to the side.
Taking out the vegetable container
cover
Lift cover, pull forwards and swivel
■
out to the side.
Inserting vegetable container cover
and partition
~ Fig. +
Insert vegetable container cover.
1.
Insert partition.
2.
In order to be able to insert
Note:
the partition, you must set the
humidity controller to the lowest air
humidity setting.
Telescopic rails
~ Fig. ,
Removing telescopic rails
Pull out telescopic rail.
1.
Push lock in the direction of the
2.
arrow.
Detach telescopic rail from the rear
3.
pin.
Push telescopic rail together, push
4.
backwards above the rear pin and
disengage.
Installing telescopic rails
Place the extended telescopic rail on
1.
the front pin.
Pull the telescopic rail forwards
2.
slightly until it engages.
Insert telescopic rail on the rear pin.
3.
Push lock backwards.
4.
Cleaning en
29