Philips Baristina BAR300 Mode D'emploi page 23

English
26
Troubleshooting
Problem
The light in the button blinks but
the appliance does not operate.
The appliance does not froth.
3 Remove the whisk from the whisk holder and rinse the parts under hot
running water.
4 Place the whisk onto the whisk holder. Place the whisk holder with whisk into
milk frother.
5 Remove the plug from the wall socket. Clean the outside of the milk frother
with a moist cloth.
This chapter summarizes the most common problems you could encounter with
the milk frother.
Possible cause
You just prepared hot frothed milk or
hot milk and pressed the button for
milk or hot frothed milk again
without letting the appliance cool
down.
The temperature of the milk is too
high.
You have not placed the lid properly
on the appliance.
You did not attach the frothing coil to
the coil holder.
Solution
If you want to prepare hot
frothed milk or hot milk
again, the milk jug needs to
cool down for a few minutes
before you can use it again.
As long as the milk jug is still
hot, the temperature limiter
makes sure that the appliance
cannot be operated. You can
rinse the inside of the milk jug
with cold water to let it cool
down faster.
Replace the warm milk with
cold milk or let the appliance
cool down.
Place the lid properly.
Attach the frothing coil to the
coil holder.