Publicité
Les langues disponibles
Les langues disponibles
Adjusting Top Plate Tension
Use the Allen key supplied to adjust the tension of the top plate. Turn clockwise to tighten, anti-clockwise
to loosen.
Note: It is possible to tighten the plate so that it sits in the open position (if
required).
BUFFALO recommend the appliance is disconnected from the power supply and allowed to cool before
any adjustments are made.
Using the timer
The digital timer with audible alarm can be set from 1 second to 15 minutes. The timer provides an
audible alarm after the set time expires. It provides no electrical control over the unit.
•
START/STOP: Press START/STOP to start timer, press again
to stop. The timer will provide an audible alarm after the
set time. The alarm will beep 10 times and the display will
continue to flash until timer is reset (press the START/STOP
button).
UP: Press UP to add extra time.
•
DOWN: Press DOWN to reduce time.
•
•
PROGRAM: There are a total of 6 programmable timer settings. The default factory program settings
are given below.
Program
Factory preset time
•
To change the length of a program select the program you want to change by scrolling using the
PROGRAM button.
•
Adjust the program time by using the UP and DOWN buttons. Press START/STOP to commence the
count-down. The new program time will be automatically stored.
•
If the unit is left without power for more than 24hrs the timer settings will revert to the factory
defaults.
Cleaning, Care & Maintenance
If grease is permitted to accumulate, it will begin to carbonise into a hard substance that is extremely
difficult to remove. To prevent this, follow the cleaning steps below:
•
Always turn OFF the appliance and disconnect from the power supply before cleaning.
•
Allow the appliance to cool before cleaning, but for best results clean the plates when they are still
slightly warm.
•
Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
•
Take care when using scrapers to remove cooking residues as they can damage the cooking surface.
•
Dry thoroughly after cleaning.
•
A BUFFALO dealer or qualified technician should carry out repairs if required.
FC380-FC386_ML_A5_v2 20200324.indb 5
1
2
3
4
00:30 01:00 01:30 02:00 02:30 03:00
UK
5
6
5
2020/3/24 16:27
Publicité
