Blaupunkt BEA 60 Mode D'emploi page 4

ENGLISH
General information
The BEA 60 unit is a four-channel equalizer
which incorporates an amplifier and a fader
for two and/or four speakers. It can be
connected to either kind of car radio without
integrated booster/amplifier.
For connecting the unit, read through the
mounting and connection instructions.
The amplifier is automatically switched on
and off together with the car radio.
The equalizer can be switched off.
Traffic security
As a motorist you must dedicate your full
attention to the traffic around you. Therefore
always use your car radio such that to be
able to cope with the current traffic situation
in any moment.
In critical situations it is not advisable to use
the car radio set, since careless driving can
lead to bad consequences. Do not forget
that at a speed of 50 km/h you are already
covering a distance of almost 14 m a se-
cond.
When adjusting the volume, make sure that
any external acoustic signals can still be
heard in order to react accordingly.
The following has to be taken into consi-
deration when connecting a car radio with
ARI traffic information:
6
If the volume is automatically in creased for
traffic messages, it is advisable to reduce
the normal radio volume. If not, the traffic
messages will be represented very loud
due to the high amplifying level. This could
make you startle and thus lead to undesired
reactions while driving.
Short description
1 EQ button (Equalizer)
The EQ button is used to switch the
equalizer on and off. When it is switched
on, the slide controls for the different
frequencies are illuminated.
2 Fader
Use this button to adjust the front/rear
volume
front speakers louder
rear speakers louder
When using two speakers only, turn
the fader into the direction of the spea-
kers in use.
3 Frequency control
The frequency control is used to incre-
ase or lower the different frequency
ranges.
When the equalizer is switched on, the
slide controls are illuminated, giving
you the opportunity to check the fre-
quency control positions even while
travelling at night.
4 GAIN ADJ
The control knob is located on the rear
side of the set. Use it to adjust the input
sensitivity.
5 PREAMP-INPUT
Adjusting the input sensitivity of the
amplifier using the GAIN ADJust knob 4
is carried out while installing the set.
When connecting Blaupunkt units, set the
voltage to 2 V.
The adjusting range 4 covers all voltages
from 0.3 to 2 V.
Each scale mark corresponds to approxi-
mately 0.33 V.
When connecting the car radio of a different
manufacturer via PREAMP INPUT 5, the
input sensitivity has to be adapted to the
corre-sponding specifications.