Publicité
Les langues disponibles
Les langues disponibles
INSTALLING THE SHELVES:
1. Open the door completely.
2. Push the shelf tracks a xed to the walls of the inner cabinet to the rear of the unit so that the tracks are
fully seated inside the cooler compartment.
3. Line up the rails
cabinet walls.
4. Push the front of the shelf inwards evenly
close the door.
5. The shelf should glide smoothly back and forth. If it does not, you may need to remove it and start over.
REMOVING THE SHELVES:
1. Open the door completely.
2. Remove all of the contents loaded on the shelf, if applicable.
3. Pull the shelf towards yourself
4. The shelf has
the
post on the right side down while pulling up on the le plas c post. You may choose to do this
by hand or by using a
5. Evenly pull out the shelf from the track
Tip: To prevent damaging the door gasket, make sure to open the door fully before pulling the shelves out
of their tracks.
Note: The cooler may experience decreased cooling e ciency if air
loaded cabinet.
ed to the shelf with the corresponding wine cooler tracks
it is fully extended outward.
posts on both sides as indicated in the diagram below. While facing the unit, press
ead screwdriver.
the shelf rests fully inside of the unit and you are able to
it is completely removed from the inner compartment.
is restricted due to a fully
6
to the inner
Publicité
