INSTALLATION INSTRUCTIONS
Accessories
Do not discard any of the accessories until installation is complete. Materials provided are needed for installation work.
Please check to make sure the accessory bag is complete.
No
Definition
Installation
1
Instructions
2
Rubber Plug
3
Sheath
4
Reducing Pipe
5
Zip Ties
Overview of Unit
NOTES:
• The total indoor unit capacity should be less than or equal to the total outdoor unit capacity if all the outdoor units
operate at the same time in one system. Overloading operations may occur in bad operating condition or some special
conditions. The total indoor units capacity should be no more than 130% of the out door unit capacity.
• The total indoor units capacity should be less than the total outdoor unit capacity if the system operates in high heat
load or very cold areas. (ambient temperature below 14° F (10°C).
• To choose wire combinations and switch disconnections, refer to the unit specification guide.
8
Graphic
(072)
(096)
(168)
(192)
Qty.
1
1
1
(120)
(144)
(216)
(240)
4
Remarks
Place Position
Single Line
Protection
Power Line
Protection
Accessory Bag
Reducint Pipe
Gas Liquid
Pipe Insulation
Binding
49-5000878 Rev. 0