Publicité
Les langues disponibles
Les langues disponibles
DUE TO VARYING ANGLES OF VEHICLE SEAT BELT
RETRACTORS, EXCESS SLACK IN THE VEHICLE BELT
SYSTEM MIGHT NOT BE REMOVED AUTOMATICALLY.
Once the lap and shoulder portions of the seat belt
are properly positioned and the buckle is attached,
FEED ANY REMAINING SLACK OF THE SEAT BELT
MANUALLY BACK INTO THE RETRACTOR TO TIGHTEN
THE WHOLE SYSTEM.
1. Place the booster seat flush against a forward-facing
vehicle seat. The vehicle seat MUST be equipped
with a 3-point lap-and-shoulder belt. Booster must
be level, stable and not rock
side-to-side (see "Vehicle seating
positions").
2. Place child in the booster seat with
child's back flat against the back of
the booster seat.
!
TIP: The expandable side protection
will automatically adjust to the
child's size ❶.
3. Adjust headrest height so that
the shoulder belt is EVEN WITH
or JUST ABOVE the top of the
child's shoulders ❷. See section
"Headrest height adjustment".
4. Thread shoulder belt
portion of the 3-point
lap-and-shoulder belt
system through the
shoulder belt guide
❸ and ensure that
shoulder belt lies across child's
21
INSTALLATION
WARNING!
!
❶
❷
❸
❹
Publicité
