Publicité
Les langues disponibles
Les langues disponibles
A
B
D
C
SPECIFICATIONS
ACCESSORIES
1/4" (6 mm) NPT quick coupler
Chuck key
Tool lubricating oil
FUNCTIONAL DESCRIPTION
Figure 1 names the major components of the reversible air drill:
A. Chuck
B. Trigger
C. Air Inlet
D. Forward/Reverse knob
Fig.1
SETUP & OPERATION
BEFORE YOU START
Compatible Compressor & Air Tool - Guidelines for Proper Usage & Operation
Always ensure the use of appropriately matched air tools and compressors. Be sure
that the air compressor being used can supply the appropriate volume, pressure and
delivery rate of air to the tool(s) without running continuously. Using tools or
combinations of tools that together or separately require more than the air compressor
can deliver will reduce performance and could void the compressor or tool warranty.
AIR SYSTEM (Fig.2)
1.
Always use clean, dry and regulated, compressed air at a working pressure of
between 75 and 90 PSI.
2.
Never exceed the maximum pressure of 90 PSI. Operating the tool with excessive
pressure could cause personal injury, and may result in excessive noise and
damage to the tool.
3.
Keep hands and other parts of the body away from the tool's discharge and
working areas when connecting the air supply.
4.
It is recommended that a filter-regulator-lubricator be used, and that it be located
as close to the tool as possible.
5.
If a filter-regulator-lubricator is not installed, place up to 6 drops of compressor oil
into the NPT inlet plug before each use.
6.
If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will
reduce the air pressure to the tool, which will cause a reduction in power,
efficiency, and general performance.
7.
For optimal performance, install a quick connector to the tool and a quick coupler
on the hose, if applicable.
8.
Verify that all of the connections in the air supply system are sealed in order to
prevent air from leaking.
1
1
1
17
Publicité
