Publicité
Les langues disponibles
Les langues disponibles
ADDITIONAL SAFETY INSTRUCTIONS FOR REVERSIBLE AIR DRILL
Inspect the reversible air drill prior to each use in order to:
a) ensure that the proper power source is being used;
b) verify that the tool is in proper working order.
Do not use a tool that is not in proper working order.
Do not use oxygen or any other combustible or bottled gas to power this tool.
Do not use this tool in the presence of flammable liquids or gases.
Only use accessories that are specifically designed for use with this tool.
Drain the air tank daily. Water in the air line will damage the air drill.
Clean the air inlet filter weekly.
The pressure in the line should be increased in order to compensate for an
unusually long air hose (longer than 26' [8 m]). The diameter of the hose should
be 3/8" (10 mm) ID.
Keep the hose away from heat, oil, and sharp edges. Check the hose for wear,
and verify that all connections are secure.
Verify that the reversible air drill is switched off before connecting it to the air
supply.
Disconnect the reversible air drill from the air supply before changing drill bit,
and before performing any type of servicing.
WARNING! Verify that drilling accessories that are used with this tool are rated at or
above the tool's speed rating. Failure to properly match the accessory to the tool
could result in serious personal injury.
Keep air-powered tools clean and lubricated. Daily lubrication is essential in
order to avoid internal corrosion and possible failure.
Using only lightweight coil hoses from the tool to the wall or to the compressor
coupling.
Do not overload the tool. For maximum efficiency, allow the tool to operate at its
optimum speed.
Do not increase the air pressure above the manufacturer's recommended level.
Doing so will cause excessive wear on moving parts, and possible failure.
In the interests of safety and in order to avoid possible damage to the tool and
injury to the operator, verify that the tool has come to a complete stop before
putting it down after use.
Verify that the workpiece is secure in order to free both hands to control the air
drill.
Verify that accessories, such as discs, are rated/designed for use with this air
drill. Verify that they are correctly and securely fastened before connecting the
tool to the air supply.
When drilling, always wear an appropriate face mask and/or respiratory
equipment.
Do not direct air from the air hose at the operator or at others.
When the air drill is not used, disconnect it from the air supply, and store in a
safe, dry, childproof location.
SPECIFICATIONS
This HAUSSMANN XPERT 3/8" (10 mm) reversible air drill is designed for drilling, hole
sawing, cylinder honing. Its housing is made of durable lightweight aluminum. Its
reversible function is used to clear jams and replace screws.
Drilling capacity: 3/8" (10 mm)
No-load speed: 1,800 RPM
Average air consumption: 3.7 CFM (106 L/min)
Operating pressure: 90 PSI
Air inlet: 1/4" (6 mm) NPT
Air hose: 3/8" (10 mm) I.D.
16
PNT112-B
!
Publicité
