A. ELECTRIC MOTOR: The motor is used to power the pump.
AIR COMPRESSOR PUMP: The pump is used to compress the air and discharge it
into the tank via the piston moving up and down in the cylinder.
B. ON/OFF SWITCH: This switch turns on the compressor and is operated manually.
When in the ON position, it allows the compressor to start up or shut down
automatically, without warning, upon air demand. ALWAYS set this switch to OFF
when the compressor is not being used, and before unplugging the compressor.
C. QUICK COUPLER:The quick coupler is connected to a quick connector which is connecting
to air hose.
D. REGULATED PRESSURE GAUGE: The gauge is used to measure the regulated
outlet pressure.
E. TANK PRESSURE GAUGE: The gauge is used to measure the store air pressure level
of the tank. It is not adjustable by the operator, and does not indicate line pressure.
F. AIR PRESSURE REGULATOR: The regulator is used to adjust line pressure to the tool
you are using. Turn the knob clockwise to increase pressure and counterclockwise
to decrease pressure.
G. PRESSURE RELIEF VALVE: The valve is used to prevent system failures by relieving
pressure from the system. When the pressure reaches the preset level the pressure
switch will not shut down the motor, it will automatically pop open or you can pull
the ring on the valve to open.
Never attempt to open the drain valve when the tank pressure
is more than 10 PSI.
H. AIR TANK: The tank is used to store the compressed air.
I . DRAIN VALVE: The drain valve is used to remove moisture from the air tank after
J. POWER CORD: This product is for use on a nominal 120-volt circuit and should
be grounded. A cord with a grounding plug must be used. Make sure the product
is connected to an outlet having the same con guration as the plug (see Figure 1).
No adapter should be used with this product.
Check with a licensed electrician if the grounding instructions are not understood
or there is doubt as to whether the product is properly grounded. Do not modify
the plug provided. If it will not t the outlet, have the proper outlet installed by
a licensed electrician.
7
WARNING