REV Ritter L19550 Mode D'emploi page 10

SAFETY INSTRUCTIONS FOR BATTERIES
• Do not attempt to revive batteries or rechargeable batteries by heating or similar measures. Primary batteries
must not be recharged as this can lead to electrolyte leakage, explosion or fire.
SCOPE OF DELIVERY
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• Product
• Instructions
• USB charging cable
TECHNICAL DATA
• Output: 2x10W LED
• Illuminant: COB LED´s
• Luminous flux: 2x900lm
• Colour temperature: 6500K
• Colour rendering index (Ra/CRI): ≥ 65
• Energy efficiency class: A+
• LED service life: 30.000h
• Beam angle: 80°
• IP protection class: IP20
• Protection class: III (S5)
• Ambient temperature: -20°C – 50°C
• Dimensions W x H x D: folded: 297 x 210 x 80mm; folded out: 297 x 297 x 70mm
• Weight: 1710g
• Battery: 3.7V / 8000mAh / lithium polymer battery (126090) / 29,6Wh
• USB: Micro IN 5VDC, max. 2A; USB OUT 5VDC, max. 2A
OPERATION
• Charging: Before (first) use, fully charge the product until the charge indicator light turns green
• Charging time: 6 hours (depending on the selected USB power supply)
• Duration: 3 hours (1700lm) / 5 hours (900lm)
• 1x press: one side (900lm)
• 2x press: opposite side (900lm)
• 3x press: both sides (1700lm)
• 4x press: OFF
CLEANING
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
• Never spray for cleaning or use a steam pressure cleaner, as this may damage the insulation and seals!
MAINTENANCE
• Remove all dirt from the housing or protective panel immediately, as this can lead to overheating.
• The light source of this luminaire is not replaceable; if the light source has reached the end of its service life, the
entire luminaire must be replaced.
GB
10