Adler europe AD 3056 Mode D'emploi page 4

device (RCD) in the power circuit, with residual current rating not more than 30 mA.
Contact professional electrician in this matter.
15. Accessible surface temperatures can be high when the appliance is operating.
Never touch the hot surfaces of the appliance.
16. Due to the high temperature you should be careful when removing the prepared
dishes, removing hot grease or other hot liquids.
presence during use of the appliance.
17. This electrical appliance contains a heating function. Surfaces, also different than the
functional surfaces, can develop high temperatures. The equipment shall be touch only at
intended handles and gripping surfaces, and use heat protection like gloves or similar.
During or after use, please do not touch the baking tray or the hot area on the shell before
the temperature goes down.
18. The device must cool down before you store it.
or meltable objects in the device.
20. The device is not designed to work with external schedulers or separate remote control
system.
21.
destruction of the device.
22.The power cord may not be placed above the device and it may not touch or be located
near hot surfaces. Do not place the device under a mains socket.
23. Do not move or carry the device during operation. After the operation it can be moved
only if it had enough time for cooling down.
24. Open device by holding the handle.
DESCRIPTION OF DEVICE
1. lid
3. ready indicator (green)
BEFORE FIRST USE
1. Remove all cartons and labels from housing and from inside (between hotplates).
3. Apply a bit of edible oil or other plant fat to the trays,
4. Keep the appliance running for few minutes to get ride of manufacturing odour. Device could emit some smoke during this time.
That's normal.
5. Clean unit according chapter "Cleaning ".
USING DEVICE
Prepare needed products.
1. Closed appliance plug in grounded socket - power indicator lamp will light (2).
2. Wait about 10 minutes. After this time device should reach required temperature - ready indicator lamp will light (3).
3. Fully open the device. Put on the bottom baking tray prepared product.
Close the device
5. During operation the ready indicator lamp (3) will be turning on and off, that's mean that thermostat keep appropriate temperature of
the hotplates.
6. Operation time is approximately 5 to 15 minutes
CAUTION: During operation from the cover of the device there can emit hot steam.
ATTENTION! Do not use metal utensils or sharp kitchen tools because they can damage the special non-stick coating heating plates.
8. Before cooking the next batch of products, close the device to the heating plate gets hot to the proper temperature. Illuminating of the
thermostat (3) indicates readiness to baking.
Be careful, there can be hot steam
2. Power indicator (red)
4. Temperature control knob
close and plug in, the power indicator lamp will light (2).
and depends on type of used ingredients and taste preference.
4