Beamz SB02 MKII Mode D'emploi page 5

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and
have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be returned to
the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water
might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to this, all
other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and may be used. No
dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground to
avoid the risk of electrocution or fire.
The integrated 38mm stand flange allows the ShowBar to be mounted on any suitable lighting stand. If you place the
ShowBar on a lighting stand, you can use the fixation screw to fasten the ShowBar.
• Please make sure the load is installed in a balanced way and the carrying capacity of the stand is not
exceeded.
• Install the stand on a plane area (inclination angle max. 5°) and out of the reach of people.
• Depending upon the individual installation spot, all necessary measures to prevent displacement or tilting
(also in case of fire) have to be taken.
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX input of the first unit in a DMX chain.
Always connect the output of one unit with the input of the next unit until all units are connected.
At the last unit, you must close the DMX line with a terminating resistor. Take an XLR connector and solder a 120 Ohm resistor
between signal (-) and signal (+) and connect it to the DMX output of the last unit in the line.
Remote controller is delivered without battery, Please place 2x AAA battery through the back of the remote control.
Press button up or down to change program in AUTO mode.
Select sound mode
Save the current setting
Select auto mode
Select the DMX mode, press again to select another DMX mode.