Sammic GS25A Mode D'emploi page 6

E N G L I S H
3.Connection to Drainage
Drainage should be located lower to the machine level, at 150 mm (5.91 inches) minimum.
It is convenient that the drainage pipe is of 30 mm (1.18 in) of interior diameter and with a minimum gradient of 3 cm
(1.18 in) per meter (see figure).
Descending
ELECTRICAL CONNECTION
IT IS MANDATORY TO GROUND THE EQUIPMENT.
To avoid possible discharges on individuals or damages to the equipment, the machine should be
grounded pursuant local and/or national regulations as the case may be.
THE MANUFACTURER SHALL BE HELD HARMLESS IN CASE OF DAMAGES ARISING DUE TO THE LACK
OF THE GROUND INSTALLATION.
The machine is supplied with a 1.5 m (4.92 feet) cable of length. In case the supply cable is damaged, it should be repla-
ced by a cable of special assembly to be furnished by the manufacturer or post-sale service. Such replacement should be
performed by qualified technical service only.
The machine should be places in such a way as to allow a minimum space between the back and the wall to allow an easy
access and without risks to the cable jack.
Safeguard the base of the jack.
4
1.Water and drainage
Water quality has a remarkable influence on the appearance,
hardness and flavor of the ice as well as, on the machines con-
densated by water, on the life of the condenser.
2.Connections To The Water Network
Use a flexible pipe (1.3 m - 4.27 feet length) with the two filter
joints supplied with the machine. We strongly discourage the
use of two-exit bibs and two switches as, due to an error could
close that back one, leaving the machine without water supply.
This could result on a damage call without actually existing one.
Pressure should be established between 0.7 Bar (10 / 85 psi.)
If pressures overpass such values, install the necessary corrective
devices.
CORRECT
INCORRECT
INCORRECT
Ascending