Setup
Registering the
smart plug
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the smart plug, it
must be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks in green.
2
Smart plug:
Press and hold M
LED indicator blinks in green
(page 6).
R When registration is complete,
Note:
R To cancel the registration, press the
registration button on the hub and
on the smart plug.
R If registration fails, the hub sounds
several short beeps.
8
HNA101C̲(en̲en)̲0916̲ver.022.pdf 8
OTHER
N until the
the hub sounds one long beep.
For assistance, visit www.panasonic.ca/english/support
Using the app
When you register the smart plug by
using the [Home Network] app, you
can assign a name to your devices and
group them by location. For more
information, refer to the User's Guide
(page 9).
Wireless
communication
range
The wireless communication range of
each device in the system from the hub
is approximately 50 m (160 feet)
indoors and approximately 300 m
(1,000 feet) outdoors. Wireless
communication may be unreliable
when the following obstacles are
located between the hub and other
devices.
R Metal doors or screens
R Walls containing aluminum-sheet
insulation
R Walls made of concrete or
corrugated iron
R Double-pane glass windows
R Multiple walls
R When using each device on
separate floors or in different
buildings
Note:
R The LED indicator blinks in red if it is
out of range of the hub. In this case,
confirm all connections, including
those of the hub.
2014/09/16 20:47:46