GreenWorks ISG301 Manuel D'opérateur page 6

5. Discard the box and package in compliance with
local regulations.
6.2 INSTALL THE BATTERY PACK
Figure 2.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
6.3 REMOVE THE BATTERY PACK
Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
6.4 INSTALL THE BIT
Figure 4.
1. Push reversing button in the center position to lock
the switch trigger.
2. Move the coupler forward and hold in position.
3. Put bit straight into coupler.
4. Release the couple.
NOTE
Use only impact quality bits with a locking groove.
WARNING
Make sure that you attach the bit tight in the coupler
before you use the machine.
6.5 REMOVE THE BIT
Figure 5.
1. Push reversing button in the center position to lock
the switch trigger.
2. Move the coupler forward and hold in position.
3. Pull the bit straight out of the coupler.
English
7 OPERATION
Always wear eye protection.
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
7.1 START THE MACHINE
Figure 6.
The machine can not work until the reversing button is
pushed fully to the left or right. Do not operate the
machine at low speeds for extended periods of time.
1. Push the switch trigger to turn the machine ON (I).
7.2 STOP THE MACHINE
Figure 6.
1. Release the switch trigge to turn the machine OFF
(O).
Release the switch trigger and let the coupler to come
to a complete stop.
7.3 ADJUST THE TURNING
DIRECTION
Figure 7.
The machine has the reversing button (forward/reverse
lock) above the switch trigger to chang the direction of
the bit.
1. When the reversing button is on the left side of the
switch trigger, the bit direciton is forward.
2. When the reversing button is on the right side of the
switch trigger, the bit direction is reversible.
3. Put the direction button in the OFF (center lock)
position to help decrease the possibility of
accidental start when not operate.
Let the coupler to come to a complete stop before
changing the direction of rotation.
7.4 OPERATE THE MACHINE
Figure 8.
1. Put the lock-off button in the correct position for the
operation.
2. Hold the machine with one hand.
7
WARNING
WARNING
NOTE
WARNING
WARNING
EN