Publicité
Les langues disponibles
Les langues disponibles
setting up your washer
3. Check the inlet hose to ensure a washer is inside each fill
hose.
Thread the inlet hoses to the HOT and COLD faucet
connections.
On the other end of the hose, check for one rubber
washer per hose and install each fill hose to the water
valve. Make sure the hose with the Hot printed line is
attached to the HOT faucet. Tighten by hand until snug,
then two-thirds of a turn with pliers.
For correct water use, connect both HOT and COLD
water valves. If either or both are not connected, an "nF"
(no fill) error can occur.
4. Turn on the "HOT" and "COLD "water supply and check
all connections at the water valve and the faucet for leaks.
5. Plug the power cord into a 3-prong, well grounded 120 volt
60 Hz approved electrical outlet protected by a 15-amp
fuse or comparable circuit breaker.
Your washer is grounded through the third prong of the
power cord when plugged into a three-prong grounded
receptacle.
6. Slide your washer into position.
7. Level your washer by turning the leveling legs in or out as
necessary by hand or by using the wrench included with
your washer.
When your washer is level, tighten the locking nuts using
the wrench or (-) flathead screwdriver.
Your washer must be leveled on all four sides. A
carpenter's level should be used on all four corners of
your washer. It's the best to recheck after the first dozen
washes.
Avoid damage to the legs. Do not move
the washer unless the locking-nuts are
fastened to the bottom of the washer.
16_ setting up your new washing machine
WF409SNL-02657C_EN.indd 16
Cold
Hot
Rubber
Washer
Cold printed
Hot printed
2009-05-12 ¿ÀÈÄ 8:26:50
Publicité
