Télécharger Imprimer la page

Sunbeam SWM5251-CN Manuel D'instructions page 3

Publicité

22. DO NOT pour water in any openings other than the
water tank.
23. If you have a warm mist humidifier, allow unit to cool
before refilling water tank or maintenance as the heater
bulb is hot.
24. To prevent damage to surfaces, do not place humidifier
under overhanging surfaces.
25. NEVER operate unit without water in the tank.
26. Do not move unit after it has been used until unit cools
completely.
27. Use both hands when carrying full tank of water.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
CONSUMER SAFETY INFORMATION
NOTE: This is an electrical appliance and requires attention
when in use.
NOTE: If moisture forms on the walls or windows of the
room, turn off the humidifier. The room already has plenty of
humidity and additional moisture may cause damage.
NOTE: DO NOT block air inlet or outlet.
Cord and Plug Installation Safety Instructions:
The length of cord used on this appliance was selected to
reduce the hazards of becoming tangled in, or tripping over a
longer cord. If a longer cord is necessary an approved
extension cord may be used. The electrical rating of the
extension cord must be equal to or greater than the rating of
the humidifier (refer to the rating information placed on the
humidifier). Care must be taken to arrange the extension cord
so that it will not drape over the countertop or tabletop where
it can be pulled on by children or accidentally tripped over.
HOW WARM MIST WORKS
Your Sunbeam
Warm Mist humidifier is designed to allow
TM
the proper amount of water to flow out of the tank. Air is
drawn in through the grill openings located in the back of the
unit and mixed with steam in the misting chamber. The warm
mist is then dispersed out of the top of the misting chamber
through the outlet grill and into the room.
F E AT U R E S - O P E R AT I O N S
NOTE: A humidity level below 20% can be unhealthy and
uncomfortable. The recommended humidity level is between
40%-50%.
PRE-OPERATING INSTRUCTIONS
1. Be sure the humidifier is switched off.
2. Select a location for your humidifier, on a flat level
surface about 4 inches (10 cm) away from the wall. DO
NOT place the humidifier on a finished floor or near
furniture, which can be damaged by too much moisture
or water. Place on a moisture resistant surface.
3. Remove the tank from the main housing.
4. This humidifier holds about 0.9 gallons of water in
the tank and humidifier base. The humidifier will
produce up to 2.5 gallons of water over a 24-hour
time period.
5. Make sure the safety lock is rotated completely to the
locked position. Place tank back on to the base. The tank
will immediately begin to empty into the base.
6. Plug the humidifier into a 120V electrical outlet.
OPERATING INSTRUCTIONS
1. To turn the unit on, switch the knob to the High (2)
position. High will produce the maximum moisture and
Low will produce the longest run time and quieter
performance. The power light ( ) will be on. It is
normal for the humidifier to take 10 minutes to boil the
water and begin to mist.
2. To turn the unit to low, switch the knob to the LOW (1)
position. To turn the unit off, switch the knob to Off ( ).
3. The Medicine cup is located on the top of the mist
chamber. To use, pour designated humidifier medication
into the cup. DO NOT add medication to the water tank.
DO NOT add medication to the medicine cup when the
unit is already operating.
RESET PROCEDURE
NOTE: When the water in the tank is empty and the water in
the heating chamber is almost empty, the Automatic Shut Off
will activate. The RESET light ( ) will illuminate and the unit
will not operate again until you refill the water tank and
reset the humidifier as outlined below.
1. Turn the power knob to Off ( ).
2. Unplug the unit.

Publicité

loading