Tripp-Lite SmartPro SMX2200XLRT2U Manuel Du Propriétaire page 12

Battery Replacement
Under normal conditions, the original batteries in your UPS will last many years. See Safety
section before replacing batteries. The batteries are designed for hot-swap replacement (i.e. leaving the
UPS in ON mode), but some qualified service personnel may wish to put the UPS in the OFF mode
and disconnect equipment before proceeding.
Remove Front Panel
1
Disconnect Batteries
2
3 Remove/Dispose of Batteries
4 Add Batteries
Connect Batteries
5
Attach connectors: black-to-black and red-to-red.
Replace Front Panel
6
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number can be found on the product name-
plate label, along with all required approval markings and information. When requesting compliance information for this product, always refer to the series number. The series number should not be
confused with the marking name or model number of the product.
This product designed and engineered in the USA.
Note on Labeling
Two symbols are used on the label.
V~ : AC Voltage
V : DC Voltage
Procedure
12
1
2
3
6
5
4