MAYWAY FTH-30 G Notice D'installation Et D'emploi page 5

Regulation of the fl ame by the lower performance (sporo):
Adjust the low performance (sporo) and then regulate the fl ame with screw which is situated in the body of the
tap next to the tap shaft.
Process of regulation:
• remove the regulation tap knob (pull to yourself)
• there is slot for regulation next to the tap shaft
• regulate the fl ame with the small fl at screwer
Maintenance:
We recommend you to have the device checked once a year by proffesional service. Only qualifi ed or competent
persons can do interventions in the product.
It may be necessary to exchange some parts during the useful life of the device:
piezzo electrode, sensor of the thermofuse
Exchange of the piezzo electrode or thermofuse sensor: picture D
Screw up and remove the bottom cover (17), screw up the holder of the electrode and the sensor (26), disconnect
and remove the electrode (27) or sensor (23). The fi tting up of new part must be done in the contrary.
INSTRUCTION FOR USE
Attention!
When the hot-plate smokes after the fi rst switching it on it is necessary to leave the device on at least for an hour
until the smoke disappears.
Ignition of the main burner and regulation of the temperature: pictures A,B
Turn the regulation knob (2) into position „ignition of the main burner" and then press it down and hold it. Press
down the piezzo knob of the ignitor several times (1) until the main burner burns. The fl ame is visible through the
slot in the front panel. After ignition of the burner hold the knob (2) pressed several seconds till the thermofuse
gets hot. Then release the button. If the fl ame goes out repeat the whole process once more.
- lower performance sporo: picture A.B
By turning the knob (2) into position „sporo" you set the burning of the burner for sporo (lower performance).
- how to switch the whole device off: picture A,B
Turn the knob (2) into position"0".
Bowl for superfl uous oil
Check this bowl regularly and empty it in time. You must clean the bowl after each switching the device off.
ATTENTION! THIS BOWL CAN BE HOT WHEN THE DEVICE IS ON. EMPTY IT WHEN THE DEVICE IS
COLD.
1
2
Piezzo knob
1
Regulation knob
2
0
5
Switch off
Switch on the main
burner
Sporo (lower
performance)