Wagan Tech 8569 Guide D'utilisation page 3

OPERATION
1. To inititate power, insert the supplied key pin into the small hole on the front
of the light and hold for 3 seconds.
2. Short click with key pin to change between lighting modes. Mode selection
is indicated by number of red light flashes:
• Mode 1 (one flash) - 50 lumen brightness during inactivity. 2,000
lumen brightness when motion is triggered until 10 seconds after
motion stops.
• Mode 2 (two flashes) - Full darkness during inactivity. 2,000 lumen
brightness when motion is triggered until 10 seconds after motion
stops.
• Mode 3 (three flashes) - 50 lumen brightness constant illumination
(motion sensor disabled).
3. To shut off power, insert the supplied key pin into the small hole on the front
of the light and hold for 3 seconds. Light will flash once.
4. Light will turn off at sunrise.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2020 Wagan Corporation. All Rights Reserved.
2