Télécharger Imprimer la page

RealFlame T9650NG Baltic Manuel De L'utilisateur page 13

Publicité

Les langues disponibles

Les langues disponibles

Using the Igniter
1. Read and understand all operating instructions before lighting. Ensure that all protective
film has been removed from stainless burn tray prior to lighting.
2. Burner control knob must be in the "OFF" position.
3. Connect Natural Gas source (see above pages).
4. Open the Natural Gas supply to the unit.
5. Push and hold igniter button to create sparks.
6. While holding the igniter button with one hand, use
your other hand to push and turn the control knob
to the "LIGHT" position to light the burner.
7. Keep Burner Control Knob pressed in for 15-30 seconds after ignition.
After lighting, rotate the Burner Control Knob counter clockwise to "Low" setting.
9.
Observe flame, make sure all burner ports are lit. Flame height should be no higher than
13 inches tall.
10. Adjust the flame to the desired height with the
control knob .
Using a
Long Match or Lighter
1. Prior to lighting, use a shovel to move
the lava rocks for access to the burner.
2.
Wearing heat resistant gloves, position
the burning long match or burning butane
lighter near the side of the burner. DO NOT
lean over the firetable while lighting!
3. Turn control knob counter clockwise to "LIGHT".
4. Remove long match/long butane lighter.
5. After lighting, use a shovel and heat resistant
gloves to carefully move the lava rocks back
into their proper position.
6
.
After lighting, rotate the Burner Control Knob
counter clockwise to "Low" setting.
Observe flame, make sure all burner ports are lit.
Flame height should be no higher than
13 inches tall.
7. Adjust the flame to the desired height with the
control knob.
!
WARNING
If burner flame goes out during operation,
immediately turn the control knob "OFF" and let the
gas clear a minimum of 5 minutes before attempting
to re-light the fire table.
Please refer to the trouble shooting pages for
additional support, beginning on page 17.
LIGHTING INSTRUCTIONS
15
!
WARNING
When using this method to light
your fire table use heat resistant
gloves and follow the step by step
instructions. Failure to do so could
result in severe injury.
!
WARNING
while lighting Fire Table.
PUSH
8-13"
20.3 - 33.0 cm
Control Knob
IN
13

Publicité

loading