Restoring Factory Settings; Troubleshooting - Esoteric Grandioso D1x Mode D'emploi

Restoring factory settings

Settings are retained even if the power plug is disconnected .
Follow these procedures to restore the factory default settings and
erase all changes in memory .
o If the left and right channel units are linked, conducting this oper-
ation on the left channel unit will also set the right channel unit to
the same settings .
If the left and right channel units are not linked, conduct the fol-
lowing procedures for each unit separately .
1
Turn the units off.
If the power is on, press the POWER button and wait at least
30 seconds before proceeding .
2
Press the POWER button while pressing and
holding the MENU button.
When "Setup CLR" (clear settings) appears on the display, release
the MENU button .

Troubleshooting

If you experience a problem with this product, please take a moment
to review the following information before requesting service .
Moreover, be aware that the problem might be caused by something
other than this product . Please also check the operation of the con-
nected units .
If this product still does not operate correctly, contact the retailer
where you purchased it .
The Grandioso D1X does not turn on.
e Confirm that the power cords are securely connected to the
inlets on the backs of the units and to the power outlets .
e Confirm that power is being supplied to the outlets to which
the power cords are connected by, for example, connecting
other devices to them .
One or both units automatically turn off.
e This is because the automatic power saving function turned
the unit(s) off .
Press the POWER button on a unit to turn it on .
Change the automatic power saving setting(s) if necessary
(page 15) .
No sound is output from the speakers. The sound is distorted.
e Turn the power off and check the connections with the digital
audio source device, the amp and the speakers (page 8) .
e Change the input setting to the connector that is being used
for input (page 12) .
e Set this product's analog output (AOUT) setting according to
the amp connection (page 15) .
e Adjust the volume of the amplifier and other devices .
No sampling frequency for the input signal is shown on the
display.
e Turn the device that is connected to the selected input connector
on .
e Confirm that the device is properly connected to the selected
input connector .
19