Your Vacuum Cleaner; Before Using The Appliance For The First Time - Bosch Readyy'y BBHF2 Série Mode D'emploi

Masquer les pouces Voir aussi pour Readyy'y BBHF2 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 11
en
Congratulations on your purchase of a Bosch vacuum
cleaner from the Readyy'y series.
This instruction manual describes various Readyy'y
models, which means that some of the equipment fea-
tures and functions described may not apply to your
model. You should only use original Bosch accessories,
which have been specially developed for your vacuum
cleaner, to achieve the best possible vacuuming re-
sults.
Please fold out the illustrated pages.

Your vacuum cleaner

1 Floor nozzle with electric brush
2 Brush roller release button
3 Dust container
4 Motor protection filter
5 Foam filter
6 Motor unit
7 Floor tool release button
8 Hand stick handle
9 Hand stick sliding switch
10 Hand-held cordless vacuum cleaner release button
11 Hand-held cordless vacuum cleaner handle
12 Hand-held cordless vacuum sliding switch
13 Battery charging status indicator
14 Dust container release button
15 Charging cable
16 Brush roller
17 Brush roller guide rod
Before using the appliance for the first
time
1
Fig.
Carefully place the handle onto the main housing
and screw it into place.
2
Fig.
Plug the hand stick into the floor nozzle and lock it
into place.
To release the floor nozzle, press the release button
and pull the hand stick out of the nozzle.
50
Charging
!
Caution:
Before using the vacuum cleaner for the first time,
fully charge the batteries.
To charge the appliance, only use the charging cable
included with the appliance. The charging cable
must only be connected and operated as specified
on the rating plate. Do not charge the appliance at
temperatures below 0 °C or above 40 °C.
3
Fig.
To charge the vacuum cleaner, place it near to a so-
cket. The appliance can be left standing anywhere in
6
the room.
Fig.
Plug the charging cable into the connection at the
rear of the appliance.
Plug the charging cable plug into the socket.
The charging indicator is lit up red when the appli-
ance is charging.
Once the battery is fully charged, the charging in-
dicator lights up blue and goes out after a few mi-
nutes. The battery is not being charged anymore.
Disconnect the appliance from the mains briefly to
check. The indicator will then light up blue again.
It is normal for the charging cable and hand-held va-
cuum cleaner to become hot and this is not a cause
for concern.
Battery charging status indicator
The indicator shows the charging status of the battery.
„ Once the battery is fully charged, the charging indi-
cator lights up blue and goes out after a few minutes.
„ When the indicator flashes, the battery must be re-
charged.
Using the hand stick
Vacuuming
4
Fig.
Actuate the sliding switch in the direction of the ar-
row.
Controlling the suction level
5
Fig.
Slide the sliding switch into the required position in
order to set the suction power:
Position 1
Suction with the electric brush switched on.
For simple cleaning tasks on hard floors and particu-
larly low operating noise.
The appliance achieves the maximum run time at
this level.
Position 2
Vacuuming at full power and with the electric brush
switched on.
For particularly demanding cleaning tasks. The ap-
pliance achieves a shorter run time at this level.
1
2

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Readyy'y bchf2 sérieBbhf2 readyy'y sérieBchf2 readyy'y série

Table des Matières