EGO SNT2100-FC Guide D'utilisation page 27

2. Turn the snow blower on its side
(Fig. 24).
3. To reduce the risk of injury, wear
gloves. Use a socket wrench (not
included) to remove the 5 nuts
(Fig. 24). Detach the worn scraper
bar from the snow blower.
4. Attach the new scraper bar to the
snow blower with the shiny surface
facing the inside of the deck. Align
the mounting holes in the scraper
bar with the holes in the steel deck.
Insert the 5 bolts into the mounting
holes from the inside, shiny surface
of the scraper bar (Fig. 25a).
5. Place the spring washers and nuts
on the bolts (from the outside of
the deck) and use a socket wrench
(not included) to securely fasten the
scraper bar to the deck (Fig. 25b).
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2100/SNT2100-FC
24
Nut
Scraper Bar
25a
Shiny surface of
the scraper bar
25b
Bolt
Scraper bar
Nut
Spring washer
Bolt
Spring washer
Deck
Nut
27