Biesemeyer T-Square BC30 Manuel D'utilisation page 7

REAR RAIL FOR DELTA SAWS
NOTE: Do not use template to set rear rail.
3. Align the two non-countersunk holes in the rear rail
with the two holes in the rear edge of the saw table.
The two cutouts in the rear rail need to be below the
bottom of the two miter slots in the saw table.
Fasten rear rail to the saw as follows:
FOR DELTA UNISAW: Thread the two 3/8-24 x 1-1/4"
long hex head screw, lock washer and flat washer (D),
supplied, Fig. 8, through the two holes in the rail and into
the two threaded holes in the saw table.
DELTA CONTRACTOR'S SAWS AND HYBRID SAWS:
Fasten rail to the saw using the two 3/8-24 x 1-1/4" hex
head screws, lock washers, flat washers and hex nuts (E)
supplied, Fig. 9. The lock washer, flat washer and hex nut
will be on the inside edge of the saw table.
4. After fastening the rear rail to the saw table, tilt the saw
blade to make certain there is no interference between
the guard splitter and the rear rail. If there is, it will be
necessary to enlarge the cut-out (F), Fig. 9, in the rear
rail.
TABLE LEGS TO TABLE BOARD
IMPORTANT: If your saw fence system will be used
with a mobile base underneath the saw base and
table legs, the position of the legs will have to be
changed to fit the mobile base extension.
5. Assemble the 3/8" jam nut (G) onto leveling screw (H).
Thread leveling screw into bottom of support leg. Fig. 10
illustrates the foot leveling assembly on the table leg.
Assemble the remaing foot assembly to the other leg
in the same manner. NOTE: Height adjustment will be
made later.
A
F
7
C
FIG. 7
D
FIG. 8
E
FIG. 9
H
G
FIG. 10