Publicité
Les langues disponibles
Les langues disponibles
SETUP & OPERATION
1.
Always use clean, dry and regulated, compressed air at a working pressure of
between 75 and 90 PSI.
2.
Never exceed the maximum pressure of 90 PSI. Operating the tool with excessive
pressure could cause personal injury, and may result in excessive noise and
damage to the tool.
3.
Keep hands and other parts of the body away from the tool's discharge and
working areas when connecting the air supply.
4.
It is recommended that a filter-regulator-lubricator be used, and that it be located
as close to the tool as possible.
5.
If a filter-regulator-lubricator is not installed, place up to 6 drops of compressor oil
into the NPT inlet plug before each use.
6.
If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will
reduce the air pressure to the tool, which will cause a reduction in power,
efficiency, and general performance.
7.
For optimal performance, install a quick connector to the tool and a quick coupler
on the hose, if applicable.
8.
Verify that all of the connections in the air supply system are sealed in order to
prevent air from leaking.
OPERATING AIR-POWERED IMPACT WRENCH
1.
Only use impact sockets that are specifically designed for use with an air-powered
impact wrench.
2.
Connect the air-powered wrench to the air hose.
3.
Place the socket over the nut to be removed or installed, and depress the trigger
in order to operate the wrench.
4.
To change direction push the button at the front of the handle. Direction of "R" for
reverse and "F" for forward.
5.
The speed of the tool can be controlled by the air regulator.
6.
Verify that the air supply is clean, and that it does not exceed 90 PSI while
operating the wrench.
7.
Keep children away from tools and workplaces.
8.
Do not apply excessive or additional force to the wrench in order to remove a nut.
9.
Do not allow the air-powered wrench to run free for an extended period of time.
Doing so will shorten the life of the wrench.
MAINTENANCE & STORAGE
The tool owner and operator are responsible for assuring that the tool is kept in safe
working order. Furthermore only service personnel trained by the manufacturer or
distributor should repair the tool.
CAUTION: Disconnect the air-powered impact wrench from the air supply before
changing accessories, servicing, or performing maintenance. Replace or repair
!
damaged parts or accessories before using the air-powered impact wrench. Use only
recommended and properly rated replacement parts and accessories.
1.
Clean and inspect your tool every time you use it.
2.
Lubricate the air-powered impact wrench daily by dripping a few drops of air tool oil
into the air inlet.
3.
Do not use worn or damaged accessories.
4.
Check the level of lubrication in the gearbox by removing the set-screw that is
located under the tool head, and top it up if necessary.
5.
A loss of power or erratic action may be due to the following:
a) Excessive drain on the air line; moisture or restriction in the air pipe; incorrect
size or type of hose connectors. To remedy these situations, verify the air supply
and follow instructions.
b) Grit or gum deposits in the air-powered impact wrench may also reduce
performance. If the air-powered impact wrench has an air strainer (located in the
area of the air inlet), remove the strainer and clean it.
17
Publicité
