Work Men WMBD858BM Traduction Des Instructions D'origine page 14

APPLICATION
The machine is intended for hammer drilling in
concrete, brick and stone, as well as for light
chiseling work. It is also suitable for drilling without
impact in wood, metal, ceramic and plastic.
It is not designed for commercial use.
WARNING! Read this manual and
general safety instructions
carefully before using the
appliance, for your own safety.
Your power tool should only be
passed on together with these
as well as the additional safety instructions.
WARNING: Packaging materials
are not toys! Children must not
play with plastic bags! Danger of
In this manual and/or on the machine the following
symbols are used:
Warning / Danger!
Read manual before use.
Wear ear protection.
Wear eye protection.
Always wear a dust mask.
Always wear protective
Indicates electrical shock
GB HAMMER DRILL
instructions.
suffocation!
gloves.
hazard
In accordance with
essential applicable safety
standards of European
Double insulated
HAMMER SAFETY WARNINGS
Wear ear protectors. Exposure to noise can cause
hearing loss.
Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
ADDITIONAL SAFETY AND WORKING
INSTRUCTIONS
Observe the mains voltage! The voltage of the
power source must correspond with the data on
the type plate of the machine.
Use appropriate detectors to determine if utility
lines are hidden in the work area or call the local
utility company for assistance. Contact with electric
lines can lead to fire and electric shock. Damaging a
gas line can lead to explosion. Penetrating a water
line causes property damage.
Firmly tighten the auxiliary handle, hold the
machine firmly with both hands while working and
keep proper footing and balance at all times. The
machine is securely guided with both hands.
Select the correct operating mode and the
suitable application tool for the material to be
worked.
Insert the SDS-max application tool: Check the
latching by pulling the tool.
Replace a damaged dust protection cap
immediately. The dust protection cap largely prevents
the penetration of drilling dust into the tool holder
during operation. When inserting the tool, pay
attention that the dust protection cap is not damaged.
Dusts from materials such as lead-containing
coatings, some wood types, minerals and metal
can be harmful to one's health and cause allergic
reactions, lead to respiratory infections and/or
cancer. Materials containing asbestos may only be
worked by specialists.
– As far as possible, use a dust extraction system
suitable for the material.
directives
14