Kicker SubStation PE Serie Manuel Du Propriétaire page 2

Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
The space-saving KICKER SubStation™ Powered Enclosures offer the quickest and easiest way to add a
subwoofer to your vehicle. These systems have been meticulously fi ne-tuned by KICKER engineers to deliver
astounding performance and sound without the time-consuming setup required for a typical amp-sub upgrade.
PERFORMANCE
Model:
Subwoofer
RMS Power @ 14.4V
Frequency Response ± 1dB
Signal-to-Noise Ratio
Crossover
Phase Switch
Input Sensitivity
KickEQ Bass Boost
Remote Bass
Enclosure Type
Net Weight
Height
Width
Depth at base
Depth at top
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER powered subwoofer enclosure. Carefully
check the areas where the mounting straps will be placed. Make sure the mounting screws will not puncture
the gas tank/brake lines/wiring or interfere with any mechanical parts on the underside of the mounting surface.
Choose a location that allows at least 4" (10cm) of open ventilation for the amplifi er. If possible, mount the
enclosure in the climate-controlled passenger compartment.
Vented Enclosures: Do not obstruct the vent opening, and make sure you leave at least 4" [10cm] of space
around the vent. When mounting the enclosure in the extreme rear of the vehicle, point the woofer toward the
front of the vehicle for optimal bass. Conversely, if the enclosure is going to be mounted closer to the back
seat, pointing the woofer toward the rear of the vehicle will give you the best results. If it is more convenient to
mount the enclosure along a side wall, put the enclosure on the left side of the vehicle; this orientation will make
the vent point toward the rear of the vehicle for optimal bass output.
2
2011 PES10C - PECVR12 RevE.indd 2 2011 PES10C - PECVR12 RevE.indd 2
Owner's Manual
MODEL: PES10C / PECVR12
PES10C
10" [25cm] Solo Classic
450W
25–200Hz
>95dB
50–200Hz
0° / 180°
low level: 125mV–5V
high level: 250mV–10V
variable to +18dB@40Hz
included
sealed
35lbs. [16kg]
13-1/4" [337mm]
18" [457mm]
8-1/4" [210mm]
5" [127mm]
SUBSTATION™
POWERED ENCLOSURE
PECVR12
12" [30cm] CompVR
400W
25–200Hz
>95dB
50–200Hz
0° / 180°
low level: 125mV–5V
high level: 250mV–10V
variable to +18dB@40Hz
included
vented
38lbs. [17kg]
16" [406mm]
17-1/16" [433mm]
14-1/2" [368mm]
11-1/4" [286mm]
9/14/2010 1:55:49 PM 9/14/2010 1:55:49 PM