Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
e. Using the dust cap (Fig.5)
Fig. 5
f. Forward/reverse adjustment (fig. 6)
Fig. 6
g. Switch on and off (Fig.7)
Fig. 7
•
The dust cap can be used to give
added protection against dust and
debris entering the chuck.
•
Place the cap over the shank of the bit
or chisels and slide it forward until it
rests against the shoulder of the bit.
Insert the bit or chisel into the chuck
as normal.
•
For forward (clockwise) rotation,
push the forward /reverse switch to
the left position.
•
For reverse (counterclockwise)
rotation, push the forward/reverse
switch to the right position.
•
Start the tool by squeezing the
variable speed trigger switch.
Release the trigger to stop the tool.
•
If you press the lock on button while
the trigger switch is depressed,
the switch is kept in the operating
position. This is convenient when
continuous operating for extended
periods of time is required.
•
To release the lock on button, press
and release the trigger switch.
•
This tool has a variable speed switch
which can reach higher speed with
increased trigger pressure.
•
Speed is controlled by the amount of
switch trigger depression.
74 | 75
GB
Publicité
Table des Matières
