To Use - Beurer SL 70 Mode D'emploi

to the included AC Adapter. If using the AC Adapter, plug the adapter
into a 110-VAC electrical outlet.
3. While charging, the operation light flashes green and will illuminate
steadily in green when the battery is fully charged.
4. The battery should be charged in two hours. At that time, disconnect
the charging cable from the computer or AC Adapter and the micro
USB port.
5. The device will operate 4-5 days on a full charge. When the operation
light turns red, the battery level is at 41% or less.

5. To Use

1. Press and hold the ON/OFF button for three seconds; the operation
light will illuminate. The LED will shut off after a short time so it does
not disturb you while sleeping.
2. Place the device onto either ear; the right ear is shown here. Do not
bend the upper clip too much to avoid damaging the device. Turn the
earplug so that is faces into the ear canal as shown. If the earplug
moves around easily, try a larger one.
1.
3. Go to sleep. When you wake up, shut the device off by pressing and
holding the ON/OFF button for about three seconds; the device will
vibrate briefly to indicate it is switched off.
Transferring data to your mobile device
To transfer the recorded data from your snore stopper to the 'beurer
SleepQuiet' app, proceed as follows:
1. Activate Bluetooth
2. Open the 'beurer SleepQuiet' app. Press the ON/OFF button on the
snore stopper; recorded data will transfer to the smartphone. A large
volume of data may take some time.
2.
on your mobile device.
®
3.
7