Flex CHE 2-28 SDS-plus Notice D'instruction D'origine page 14

For your safety
WARNING!
Read all safety instructions and other
instructions. Failure to observe the safety
instructions and other instructions may
result in an electric shock, fire and/or serious
injuries. Save all warnings and instructions
for future reference.
Before using the power tool, please read
and follow:
these operating instructions,
–
the "General safety instructions" on the
–
handling of power tools in the enclosed
booklet (leaflet-no.: 315.915),
the currently valid site rules and the
–
regulations for the prevention of
accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may be a danger to life and limb of the user
or a third party, or the power tool or other
property may be damaged. The power tool
may be operated only if it is
as intended,
–
in perfect working order.
–
Faults which impair safety must be repaired
immediately.
Intended use
The hammer drill and chisel hammer
CHE 2-28 SDS-plus is designed
– for commercial use in industry and trade,
– for hammer drilling in masonry and
concrete for wall plug and anchor
attachments and through-holes,
– for light trimming work to remove plaster
and tiles,
– to be used with suitable tools
recommended by the manufacturer
for this power tool.
14
Safety instructions for hammers
 Wear ear protection. The effect of noise
may result in loss of hearing.
 Use auxiliary handles supplied with the
power tool. The loss of control may result
in injuries.
 Hold power tool by insulated gripping
surfaces only, when performing an
operation where the cutting accessory
may contact hidden wiring or its own
cord. Cutting accessory contacting a "live"
wire may make exposed metal parts of the
power tool "live" and shock the operator.
Additional safety instructions
 Use suitable detectors to detect
concealed power supply cables or
consult your local supply company.
Contact with electric cables may result in
a fire and/or electric shock. A damaged
gas pipe may cause an explosion. Cutting
into a water pipe will cause damage to
property or may cause an electric shock.
 When working, hold the electric power
tool firmly with both hands and ensure
that you have a secure footing.
The electric power tool is controlled more
securely if held with both hands.
 Secure the workpiece. A workpiece is
held more securely in a clamping device
than by hand.
 Do not use the electric power tool if it has
a damaged power cord. Do not touch the
damaged power cord and pull out the
mains plug if the power cord is damaged
during work. Damaged power cords
increase the risk of an electric shock.
 Only use tools with SDS-plus tool holder.
Pull on the insertion tool to check that it is
locked properly.
 Immediately have a damaged dust cap
replaced. The dust cap prevents the
ingress of dust into the tool holder.
CHE 2-28