Bestron BREAKFAST CLUB AWK1101Z Manuel D'instructions page 14

OPERATION - General information
The below description goes with the image on page 2.
1. Jug
2. Water-level indicator
3. Lid
4. Button to open the lid
5. Handle
OPERATION - Before first use
When using the jug kettle for the first time boil three jugs of water, and dispose of the boiled water.
Tip: You can use vinegar or special descaling agents for the first time.
OPERATION - Boiling water
1. Turn the jug so that the spout faces away from you.
2. Open the lid.
3. Fill the jug with the required quantity of water (at least 0.5 litres, and a maximum of 1.7 litres). Never fill
the water boiler over the "max". Otherwise the hot water can spatter out of the base.
4. Close the lid.
5. Insert the plug in the wall socket. Push down the On switch. The On/Off pilot light will illuminate.
6. The jug kettle is now switched on, and the water will now begin to heat. The jug
kettle switches off automatically a few seconds after the water has come to the boil. The On/Off pilot
light will now extinguish.
7. Remove the jug by the handle, and pour the water out.
8. When you wish to heat the water without it coming to the boil you can switch off the jug kettle at any
time you require by pushing the On/off switch.
9. Remove the plug from the wall socket when you have finished using the jug kettle.
WARNING:
• Make sure that you do not spill any water.
• Be carefull you do not contact the hot water. It can cause serious burning wounds.
OPERATION - Overheating safeguard
The jug kettle is fitted with an overheating safeguard. This will switch off the jug kettle if it is operated
without (sufficient) water. Allow the jug kettle to cool down for at least 10 minutes before using it again.
CLEANING AND MAINTENANCE
1. Remove the plug from the wall socket, and allow the appliance to cool.
2. Clean the jug with a damp cloth. Never immerse the appliance in water. Never put the appliance in a
dishwasher. Make sure that the electrical connections do not become damp.
3. If the interior of the jug has become severely discoloured, then the best way to clean it is with a damp
cloth and a little washing soda. After cleaning, rinse the jug very thoroughly.
WARNING:
• Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
• Before cleaning, make sure that the appliance is not connected to the power supply and that it has cooled down.
CLEANING AND MAINTENANCE - Descaling
Lime can be deposited on the heating element at a rate depending on the hardness of the water. For this
reason the heating element must be cleaned at regular intervals.
1. Remove the plug from the wall socket, and allow the appliance to cool.
2. Fill the jug with a vinegar solution to the MAX level, and bring to the boil.
3. Leave the jug with the vinegar solution to stand for a couple of hours.
4. Empty the jug, fill with clean water to the MAX level, and bring to the boil. Empty the jug. Repeat this process twice.
WARNING:
• Never use ammonia or similar to descale the appliance. These can be injurious to your health. Use
solely a vinegar solution, or special descaling agents available from retailers.
6. On/off switch with pilot light
7. Spout
8. Power cord and plug
14 14
EN EN