LENCO SCD-720SI Mode D'emploi page 15

Press the SOURCE button repeatedly to enter the Cassette tape mode. The display will show "TAPE". The cassette control
buttons are location at the top front of the unit.
1. Press the CASSETTE STOP/EJECT
2. Insert the cassette tape and close the door firmly.
3. Press the CASSETTE PLAY
4. Press the CASSETTE PAUSE
button to release it.
5. To stop playback, press the CASSETTE STOP/EJECT
6. While it is in stop mode, press the CASSETTE FORWARD
7. To open the cassette door during stop, press the CASSETTE STOP/EJECT
8. To open the cassette door during playback, press the CASSETTE STOP/EJECT
9. To record, press the CASSETTE PLAY
NOTE:
- Only type 1 Normal cassette tape can be used for recording.
- If there is tape slack, rewind the slack using a pencil to avoid damaging the tape or the unit.
- On the back of the cassette are left and right tabs. This tab can be broken out. If this tab is broken out, it is no longer
possible to record on that side of the cassette. When both tabs are removed, it is no longer possible to record to the
cassette. The RECORD
CASSETTE TAPE
button to open the cassette tape door.
Play side is facing forward
button to playback.
button to pause the playback. To resume the playback, press the CASSETTE PAUSE
and RECORD
button then locks and cannot be pressed anymore.
Insert the cassette tape with the tape side
facing up
button.
or REWIND button to forward or rewind the tape.
button once.
button together.
-15-
button twice.