FAN STRUCTURE
1
13
INSTALLATION
1.
Mount the pedestal (9) onto the base (11) using the 4 screws (12).
2.
Loosen the locknut (2) and mounting nut (4) of the motor shaft (6).
3.
Slide the protective rear cover (5) with the handle upwards over the motor shaft (6).
4.
Tighten the mounting nut (4) clockwise against the protective rear cover (5).
5.
Slide the fan blades (3) over the motor shaft (6).
6.
Tighten the locknut (2) anti-clockwise against the fan blades (3).
7.
Turn the clips of the protective front cover (11) outwards and hang the protective cover over the edge of the
protective rear cover. Make sure that the opening at the bottom of the protective front cover is aligned with
the opening at the bottom of the protective rear cover.
8.
Insert the screw (1) through both openings at the bottom of the protective covers and fix the covers together
using the nut.
9.
Finally, close the clips around both protective covers.
OPERATION INSTRUCTIONS
1.
Place the fan on a flat surface.
2.
Check whether the voltage corresponds to what is indicated on the product label.
3.
Insert the plug into a wall outlet.
4.
Press the 1, 2 or 3 button to activate the fan.
Position 1 provides the lowest airflow.
Position 2 provides an average airflow.
Position 3 provides a high airflow.
5.
Press the '0' button to switch off the fan.
6.
The fan oscillates automatically from left to right. If you'd like to fix its position, depress the oscillation button
(8) at the rear of the fan. The fan will then remain in that position. Pull the button (8) back up to make the fan
oscillate automatically again.
7.
You may tilt the fan by carefully moving the motor housing (7) up or down.
8.
Remove the plug from the wall outlet when not using the fan. Make sure that the fan is fully switched off
before doing so.
5
4
3
2
10
11
7
6
8
9
12
1. Protective front cover
2. Locknut
3. Fan blades
4. Mounting nut
5. Protective rear cover
6. Motor shaft
7. Motor housing
8. Oscillation button
9. Pedestal
10. Speed switches
11. Base
12. Screws
13. Fixing screw
7