Publicité
Professional Installation Notice
To comply with FCC part 15 rules in the United States, the SonicWave 231o must be professionally installed to
ensure compliance with the Part 15 certification. It is the responsibility of the operator and professional
installer to ensure that only certified systems are deployed in the United States. The use of the system in any
other combination (such as co-located antennas transmitting the same information) is expressly forbidden.
Power Supply Information
When this product's power is provided by the Ethernet cable plugged in to the "LAN(PoE)" port, this is called
"Power over Ethernet" or "PoE". The PoE source should only be UL listed marked "Class 2" or "LPS" with an
output rated 48 VDC, minimum 0.3 A, Tma: minimum 40 degrees C. Install PoE source in environmental
location as directed by PoE source manufacturer.
Connecting the Antennas
Prepare the SonicWave 231o for installation by connecting the antennas.
NOTE:
This device must be professionally installed using either the supplied antennas or approved
alternate antennas available from SonicWall.
To connect the antennas to your SonicWave 231o:
Remove all four antennas from their bags and place one on each of the antenna connectors, matching
the radio signals (5GHz or 2.4GHz) marked on the antennas to those marked below the connectors.
Matching Radio Signal Connectors
Insert the antenna base firmly into the antenna connector.
Making sure there is no cross threading, fully tighten the silver knurled fitting using your fingers to the
point that it cannot turn with moderate force. Do not use or twist the white antenna housing enclosure
while securing the antenna.
Repeat Step 2 and Step 3 for each antenna.
CAUTION:
To prevent damage to the SonicWave 231o, all RF output ports must be attached to an
approved antenna before the radios are enabled.
Installing the Mounting Bracket
The SonicWave 231o mounting kit includes hardware for mounting the unit outside on a pole or post, or on a
wall or other flat surface. The SonicWave 231o and mounting bracket are designed so that you can first attach
the mounting bracket to the pole or wall and then slide the SonicWave onto the bracket.
SonicWall SonicWave 231o
Safety and Regulatory Information
3
Publicité
